Folks

Over the holiday season my Polished Titanium Time Bomb got a bit scratched up (don't remember exactly how, only that I was lying on a floor somewhere)...

Anyways, has anyone had any experience in polishing out scratches on a polished titaninum band?? Can I use a similiar process to that used for stainless steel???

Also, is the O Engine meant to make a grinding noise as it winds???

Any comments appreciated...

About the O Engine, yes, it's supposed to sound like that. It's only noticeable in pin-drop silence anyways so I wouldn't worry too much about it.

Oh, and welcome to the Forum mate.

Isn't that noise the most beautiful sound.

I think so!

Hey JimBob... Are the scratches deep or just surface ones...

Hi Pyro - the scratches are light but still pretty obvious coz they show up against the polished finish... Any thoughts you got would be a great help. Thx....

Just to make sure its the Polished Titanium (silvery one)... And not the Titanium one (Grey finish one)... Cause I used to have a Titanium one Grey finish one... Then this product I bought took the gray finish right off...

Materials Needed...
1. Steel wool
2. Pro High Speed Rotary Tool
3. 1" Multi Ply Buffing Wheel
4. CrystalClear Pro Metal Polish


Use the steel wool to smooth out the scratches then clean off the watch from any steel wool fiber's. Then apply the CrystalClear Polish in section's otherwise you'll have a mess. Then use the Rotary Tool and Buffing Wheel on medium speed then perceed to buff and repeat... Becareful when your buffing by the unobtanium pieces they will melt... Its normal when when the CrystalClear Polish turns black just replace the Buffing Wheel... Just PM me if you got any other questions

Wow - perfect advice....Pyro - how have you been a member for 1.4 years with only 4 posts?

I've been very BUSY...LOL....:-P